Savana 2500 V8-6.6L DSL Turbo VIN 6 (2007)
Notice: Ensure proper torquing of the fuel injector line. An under-torqued fuel injector line will not seal properly and an over-torqued fuel injector
line may damage the fuel injector fitting. An improperly sealed or damaged fuel injector line or fuel injector fitting will cause a fuel leak.
5. Install the fuel injector pipes.
Tighten the pipes to 41 N.m (30 lb ft).
6. After installing the fuel injector pipes, clean the injector pipes and apply sealant at the fittings to prevent moisture and debris from collecting
between the line and fitting. Refer to Sealers, Adhesives, and Lubricants.
7. Position the engine wiring harness.
8. Position the main connector bracket to the generator bracket.
9. Install the main connector bracket bolts.
Tighten the bolts to 10 N.m (89 lb in).
10. Connect the right side main engine harness connector.