Savana 2500 V8-6.6L DSL Turbo VIN 6 (2007)
5. Remove the connector bracket bolt (2) and nut (1), and reposition the bracket.
6. Disconnect the engine wiring harness electrical connector from the intake air temperature (IAT) sensor No. 2.
7. Remove the center intake manifold 4 bolts (1).
8. Remove the center intake manifold 2 nuts (2) and 2 bolts.
9. Remove the center intake manifold.
10. Remove and discard the center intake manifold gaskets.
11. If replacing the center intake manifold, remove the IAT sensor.
Installation Procedure