Savana 2500 V8-6.6L DSL Turbo VIN 6 (2007)
6. Remove the suction hose nut from the accumulator.
7. Remove the suction hose from the accumulator.
8. Remove the suction hose from the vehicle.
9. Discard all of the used sealing washers. Cap the system openings.
Installation Procedure
1. Install new sealing washers to the suction hose.
2. Install the suction hose to the vehicle.
3. Install the suction hose to the accumulator.
Notice: Refer to Fastener Notice.
4. Install the suction hose to accumulator retaining nut.
Tighten the nut to 16 N.m (12 lb ft).