Savana 2500 V8-6.6L DSL Turbo VIN 6 (2007)
9. Inspect the injector bore for any deposits and repeat brushing if necessary.
Caution: Keep hands and face clear of glow plug holes while cranking. Hot liquid or gases may be expelled during cranking.
Caution: Wear safety glasses in order to avoid eye damage.
10. If necessary, crank the engine in order to expel any solvent before starting the engine.
1. Remove the glow plugs.
2. Disable the fuel system.
3. Disconnect the crankshaft position (CKP) sensor electrical connector.
4. Crank the engine in order to expel any excessive solvent.
5. Using the cotton swabs supplied with the kit, wipe the injector bore clean of any solvent and/or debris.
6. Connect the CKP sensor electrical connector.
7. Enable the fuel system.
8. Reinstall the glow plugs.
Installation Procedure
1. Install a NEW copper washer to the fuel injector bore.
2. Install a NEW fuel injector O-ring to the injector.
3. Install the fuel injectors with brackets.
Notice: Refer to Fastener Notice.
4. Install the fuel injector bracket bolts.
Tighten the fuel injector bracket bolts to 30 N.m (22 lb ft).
