Savana 2500 V8-6.6L DSL Turbo VIN 6 (2007)
1. Position the exhaust differential pressure sensor to the frame.
Notice: Refer to Fastener Notice.
2. Install the exhaust differential pressure sensor bracket bolt (2).
Tighten the bolt to 9 N.m (80 lb in).
3. Install the exhaust differential pressure sensor pipe assembly hoses to the sensor.
4. Position the exhaust differential pressure sensor pipe assembly hose clamps (1).
5. Connect the engine wiring harness electrical connector (1) to the exhaust differential pressure sensor.
6. Lower the vehicle.