Savana 2500 V8-6.6L DSL Turbo VIN 6 (2007)
Notice: The wheels of the vehicle must be straight ahead and the steering column in the LOCK position before disconnecting the steering column
or intermediate shaft from the steering gear. Failure to do so will cause the SIR coil assembly to become uncentered, which may cause damage to
the coil assembly.
1. Install the J 42640 in the steering column lower access hole.
2. Remove the intermediate shaft bearing.
3. Remove the upper intermediate shaft (2) to steering column retaining nut and bolt (1).
4. Disconnect the upper intermediate shaft from the steering column and remove the upper intermediate shaft.
Installation Procedure
1. Install the upper intermediate shaft and connect the upper intermediate shaft to the steering column.
Notice: Refer to Fastener Notice .
2. Install the upper intermediate shaft (2) to steering column retaining nut and bolt (1).
Tighten the nut to 62 N.m (46 lb ft).