Savana 3/4 Ton Van V6-4.3L VIN W (1998)
Brake Pedal Assy: Service and Repair
REMOVAL PROCEDURE
1. Remove the stoplamp switch and power brake booster pushrod assembly from the brake pedal pin. Refer to Stoplamp Switch Replacement.
2. Remove the instrument panel harness from the brake pedal bracket.
3. Remove the bolt to the upper brake pedal bracket.
4. Remove the nuts from the studs on the power brake booster.
5. Remove the brake pedal bracket from the vehicle.
INSTALLATION PROCEDURE
1. Install the brake pedal bracket to the vehicle.
2. Install the nuts to the studs on the power brake booster.
^
Tighten the power brake booster retaining nuts to 36 Nm (27 ft. lbs.).