Savana 3/4 Ton Van V6-4.3L VIN W (1998)
Wheel Fastener: Service and Repair
Front Suspension
REMOVAL PROCEDURE
^
Tools Required:
-
J 9746-02 Wheel Stud Remover
1. Raise the vehicle. Support the vehicle with safety stands.
2. Remove the tire and wheel assembly.
NOTICE: Support the caliper with a piece of wire to prevent damage to the brake line.
3. Remove the front brake caliper.
4. Remove the hub/rotor.
5. Remove the wheel stud using a press.
^
Support the hub/rotor using the J 9746-02. and the press bars.
^
Do not damage the wheel mounting surface on the hub/rotor flange.
INSTALLATION PROCEDURE
1. Install the wheel hub stud into the hub/rotor.
1.1. Place four washers and a nut on the stud.
1.2. Tighten until the stud is fully seated in the hub/rotor.
2. Install the hub/rotor.
3. Install the tire and wheel assembly.
4. Remove the safety stands.
5. Lower the vehicle.