Savana 3/4 Ton Van V6-4.3L VIN X (2003)
13.
Using a clean shop towel, clean up any fluid that may have leaked out of the hydraulic brake booster when removing the original valve.
14.
Position the master cylinder (and brake combination valve mounting bracket on full size pickups and utilities) on the mounting bolts on the
hydraulic brake booster.
15.
With the master cylinder mounted flush to the booster, install the nuts.
Tighten
Tighten the nuts to 33 N.m (24 lb ft).
16.
On van models, install the diagonal brace with the water deflector attached to it between the left fender and the radiator. Install the two bolts.
Tighten
Tighten bolts to 25 N.m (18 lb ft).
17.
Start the engine and verify the hydraulic brake booster operation.
18.
Turn the engine OFF and check the power steering fluid reservoir. Add fluid if necessary.
19.
Close the hood.