Savana 3/4 Ton Van V6-4.3L VIN X (2003)
Fuel: Service and Repair
FUEL SYSTEM CLEANING
1. Disconnect the negative battery cable.
CAUTION: Refer to Battery Disconnect Caution in Service Precautions.
2. Relieve fuel system pressure. Refer to Fuel Pressure Relief Procedure.
3. Drain fuel tank. Refer to Fuel Tank Draining Procedure.
4. Remove the fuel tank.
5. Remove the fuel sender assembly.
6. Inspect the fuel strainer. Replace a contaminated strainer and inspect the fuel pump.
7. Inspect the fuel pump inlet for dirt and debris. Replace the fuel pump if you find dirt or debris in the fuel pump inlet.
8. Flush the fuel tank with hot water.
IMPORTANT: When flushing the fuel tank, handle the fuel and water mixture as a hazardous material. Handle the fuel and water mixture in
accordance with all applicable local, state and federal laws and regulations.
9. Pour the water out of the fuel sender assembly opening.
10. Rock the tank to ensure that removal of the water from the tank is complete.
11. Inspect the fuel filter for contamination.
12. Replace the fuel filter if the filter is plugged.
13. Clean the fuel lines by applying air pressure in the opposite direction of the fuel flow.
IMPORTANT: Only use oil-free compressed air to blow out the fuel pipes.
14. Install the fuel sender assembly with a new seal into the fuel tank.
15. Install the fuel tank.
16. Inspect for leaks:
16.1. Turn ON the ignition for 2 seconds.
16.2. Turn OFF the ignition for 10 seconds.
16.3. Turn ON the ignition.
16.4. Inspect for fuel leaks.
