GMC Workshop Manuals
Savana 3500 V8-4.8L (2009)
Maintenance > Wheels and Tires > Wheel Fastener > Component Information > Technical Service Bulletins > All Technical Service Bulletins for Wheel Fastener: > 07-03-10-012D > Apr > 11 > Tires/Wheels - Rattle Noise from Wheel Or Hub Cap > Page 1592
4. From inside the hub cap, apply direct pressure to one side of the wheel nut cap rim (1). The wheel nut cap will tip down and pop out of the wheel
hub cap hole when enough pressure is applied. Repeat this procedure for any additional wheel nut caps that need to be replaced.
5. Flip the hub cap over on the work bench. The emblem side should be up.
6. Install the new wheel nut cap into the existing hub cap hole by applying direct pressure to the front center of the wheel nut cap.
For vehicles repaired under warranty, use the table.
|[PREV PAGE] [NEXT PAGE]|