Savana 3500 V8-4.8L (2009)
Crankshaft Position Sensor: Service and Repair
Crankshaft Position Sensor Replacement
Crankshaft Position Sensor Replacement
Removal Procedure
Warning
Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any
electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed
electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
Note: Perform the Crankshaft Position System Variation Learn (See: ) when the CKP sensor is removed or replaced.
Access To CKP Sensor
1. Disconnect the negative battery cable.
2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
3. Remove the starter. Refer to Starter Replacement (V6) (See: Starting and Charging/Starting System/Starter Motor/Service and Repair)Starter
Replacement (4.8L/5.3L/6.0L) (See: Starting and Charging/Starting System/Starter Motor/Service and Repair)Starter Replacement (6.6L) (See:
Starting and Charging/Starting System/Starter Motor/Service and Repair).
4. Disconnect the crankshaft position (CKP) sensor electrical connector.