Savana 3500 V8-4.8L (2009)
12. Inspect for leaks:
1. Turn ON the ignition for 2 seconds.
2. Turn OFF the ignition for 10 seconds.
3. Turn ON the ignition.
4. Inspect for fuel leaks.
13. Install the engine cover. Refer to Engine Cover Replacement (See: Body and Frame/Access Cover/Service and Repair).
Fuel Hose/Pipes Replacement - Chassis (Cutaway Van - Rear Tank)
Fuel Hose/Pipes Replacement - Chassis (Cutaway Van - Rear Tank)
Removal Procedure
Warning: Refer to Battery Disconnect Warning (See: Starting and Charging/Battery/Service Precautions).
1. Disconnect the negative battery cable.
2. Relieve the fuel system pressure. Refer to Fuel Pressure Relief (With CH-48027) (See: Fuel Filter/Fuel Pressure Release/Service and Repair/Fuel
Pressure Relief (With CH-48027))Fuel Pressure Relief (Without CH-48027) (See: Fuel Filter/Fuel Pressure Release/Service and Repair/Fuel
Pressure Relief (Without CH-48027)).
3. Drain the fuel tank. Refer to Fuel Tank Draining (with L59) (See: Fuel Tank/Service and Repair)Fuel Tank Draining (without L59) (See: Fuel
Tank/Service and Repair).
4. Raise the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
5. Disconnect the fuel feed pipe at the fuel filter.
6. Disconnect the chassis fuel return pipe at the rear fuel return pipe.
7. Disconnect the chassis fuel feed and return pipes at the rear fuel feed and return pipes.
8. Remove the fuel pipe retaining clips.
9. Remove the fuel feed and return pipes.
Installation Procedure
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
1. Install the fuel feed and return pipes and the fuel pipe retaining clips (2) to the frame rail (1) and tighten the bolts to 12 Nm (106 lb in).
2. Connect the chassis fuel feed and return pipes to the rear fuel feed and return pipes (2).
