GMC Workshop Manuals
Savana 3500 V8-4.8L (2009)
Powertrain Management > Transmission Control Systems > Actuators and Solenoids - Transmission and Drivetrain > Actuators and Solenoids - A/T > Shift Solenoid, A/T > Component Information > Diagrams > Diagram Information and Instructions > Page 3630
View of the connector when released from the component.
2. Disconnect the connector from the component.
3. Locate the dress cover locking tabs at the front of the connector. Using a small flat-blade tool push down on one of the locking tabs and pull the
cover up until the dress cover releases. Repeat this procedure for the other locking tab.
4. Once the front 2 locks are unlocked, lift the front of the dress cover and pull it forward.
Note: Always use care when removing a terminal position assurance (TPA) in order to avoid damaging it.
5. Remove the TPA by inserting a small flat-blade tool into the small slot on the TPA and pushing down until the TPA releases. Gently pry the TPA
out of the connector.
|[PREV PAGE] [NEXT PAGE]|