Workshop Repair Manuals

GMC Workshop Manuals

[PREV PAGE] [NEXT PAGE]

gmc Workshop Repair Guides


Savana 3500 V8-4.8L (2009)

Starting and Charging > Sensors and Switches - Starting and Charging > Battery Current Sensor > Component Information > Service and Repair

Page 1
background image

Battery Current Sensor: Service and Repair

Battery Current Sensor Replacement

Removal Procedure

1. Disconnect the instrument panel (I/P) harness electrical connector (1) from the battery current sensor.
2. Remove the negative battery cable. Refer to Battery Negative Cable Replacement (With LMM Primary)   (See: Battery/Battery

Cable/Negative/Service and Repair)Battery Negative Cable Replacement (With LMM Auxiliary)   (See: Battery/Battery Cable/Negative/Service
and Repair)Battery Negative Cable Replacement (With LY2, LMF or LY6)   (See: Battery/Battery Cable/Negative/Service and Repair)Battery
Negative Cable Replacement (With LU3 and RVS)   (See: Battery/Battery Cable/Negative/Service and Repair).

3. Cut the tie straps and electrical tape attaching the battery current sensor to the battery cable.
4. Squeeze the negative battery cable branches together.

Important:  Note the position of the battery current sensor prior to removal.

5. Slide the battery current sensor (1) off of the negative battery cable.

Installation Procedure

Starting and Charging > Sensors and Switches - Starting and Charging > Battery Current Sensor > Component Information > Service and Repair

[PREV PAGE] [NEXT PAGE]