Workshop Repair Manuals

GMC Workshop Manuals

[PREV PAGE] [NEXT PAGE]

gmc Workshop Repair Guides


Savana 3500 V8-4.8L (2009)

Transmission and Drivetrain > Actuators and Solenoids - Transmission and Drivetrain > Actuators and Solenoids - A/T > Torque Converter Clutch Solenoid, A/T > Component Information > Diagrams > Diagram Information and Instructions > Page 4309

Page 91
background image

1. Disconnect the connector from the component by pressing down on the connector position assurance (CPA).

2. Use a small flat-bladed tool to release the terminal position assurance (TPA) by inserting the tool in the small recess on the side of the connector

and pushing up until the TPA releases from the connector body. The TPA should raise just slightly. Do not try to remove the TPA.
Note:  The TPA on this connector cannot be removed unless the terminals are removed first. The TPA will come out of the connector body, but
only slightly. When the TPA is slightly raised the terminals can be removed. Using excessive force to remove the TPA with the terminals still in
the connector will damage the connector.

3. Repeat the process for the other side of the connector.

4. Ensure that the TPA is in the proper position to remove the terminals.

Transmission and Drivetrain > Actuators and Solenoids - Transmission and Drivetrain > Actuators and Solenoids - A/T > Torque Converter Clutch Solenoid, A/T > Component Information > Diagrams > Diagram Information and Instructions > Page 4309

[PREV PAGE] [NEXT PAGE]