GMC Workshop Manuals
Savana 3500 V8-4.8L (2009)
Transmission and Drivetrain > Automatic Transmission/Transaxle > Actuators and Solenoids - A/T > Torque Converter Clutch Solenoid, A/T > Component Information > Diagrams > Diagram Information and Instructions > Page 4663
After the terminal is crimped to the wire, perform the following procedure in order to replace the terminal.
1. Slide the new terminal into the correct cavity at the back of the connector.
locked in place by gently pulling on the wire.
3. Locate the terminal position assurance (TPA).
4. Use a small flat-blade tool to push the TPA until it bottoms out.
|[PREV PAGE] [NEXT PAGE]|