gmc Workshop Repair Guides

GMC Workshop Service and Repair Manuals

4L60-E/4L65-E/4L70-E - Automatic Transmission|Page 4920 > < 4L60-E/4L65-E/4L70-E - Automatic Transmission|Page 4918
Page 1
background image

Seals and Gaskets: Service and Repair
4L80-E/4L85-E -  Automatic Transmission

Manual Shift Shaft Seal Replacement

Manual Shift Shaft Seal Replacement

Tools Required

*

J 43911  Selector Shaft Seal Remover

*

J 43909  Selector Shaft Seal Installer

Removal Procedure:

1. Remove the Park/Neutral Position (PNP) Switch. Refer to Park/Neutral Position Switch Replacement   (See: Sensors and Switches -

A/T/Transmission Position Switch/Sensor/Service and Repair/4L80-E/4L85-E - Automatic Transmission).

2. Be sure that the jackscrew for J 43911   is backed off and will not interfere with installation of the removal tool. Slide the seal remover tool over

the selector shaft (2) with the threaded end of the tool towards the seal.

3. Rotate the removal tool so that the threads on the end of the tool engage the steel shell (1) of the seal. Use a wrench to be sure that the removal tool

is firmly attached to the seal shell.

4. Rotate the jackscrew in the clockwise direction to remove the seal from the bore. Discard the seal that was removed.

Installation Procedure

1. Carefully slide a new selector shaft seal (1) over the selector shaft (2) with the wide face of the steel case facing outward. Position the seal so that

it is starting to enter the seal bore.

2. Obtain J 43909   and remove the inner sleeve so that the tool will slide over the selector shaft.
3. Slide the J 43909   into position so that the end of the tool contacts the seal being installed. Use a mallet to strike the J 43909   and drive the new

seal into the seal bore until it is seated at the bottom of the bore.

4. Install the PNP Switch. Refer to Park/Neutral Position Switch Replacement   (See: Sensors and Switches - A/T/Transmission Position

Switch/Sensor/Service and Repair/4L80-E/4L85-E - Automatic Transmission).

Propeller Shaft Front Slip Yoke Oil Seal Replacement

Propeller Shaft Front Slip Yoke Oil Seal Replacement

Tools Required

*

J 38869  Rear Extension Seal Installer

*

J 6125-1B  Slide Hammer Adapter

*

J 23129  Universal Seal Remover

*

J 36850  Transjel(R)

4L60-E/4L65-E/4L70-E - Automatic Transmission|Page 4920 > < 4L60-E/4L65-E/4L70-E - Automatic Transmission|Page 4918