Savana 3500 V8-4.8L (2009)
5. If replacing the lower inner shaft housing bushing, install the inner shaft housing into a vise so that the lower inner shaft bushing bore is flush with
the jaws of the vise.
6. Install the J 45850-2 (2), J 45850-3 (3), the forcing screw, the thrust bearing, the washers, and the nuts (1) over the lower inner shaft housing
bushing as shown.
7. Remove the lower inner shaft housing bushing by holding the lower nut and tightening the upper nut of the J 45850 .
Installation Procedure