Savana 3500 V8-4.8L (2009)
12. Install the J 8614-2 (2) and the J 8614-3 (1) into the J 8614-01 (3) as shown.
13. Remove the pinon yoke by turning the J 8614-3 (1) clockwise while holding the J 8614-01 (3).
Note: Carefully pry the seal from the bore. Do not distort or scratch the aluminum case.
14. Remove the oil seal using a suitable seal removal tool.
Installation Procedure
1. Install the oil seal by doing the following:
1. Position the oil seal in the bore.
2. Install the J 33782 over the oil seal.
3. Strike the J 33782 with a hammer until the seal flange seats on the axle housing surface.
2. Apply sealant GM P/N 12346004 (Canadian P/N 10953480) or equivalent to the splines of the drive pinion yoke.