Workshop Repair Manuals

GMC Workshop Manuals

[PREV PAGE] [NEXT PAGE]

gmc Workshop Repair Guides


Savana 3500 V8-4.8L (2009)

Transmission and Drivetrain > Drive Axles, Bearings and Joints > Seals and Gaskets, Drive Axles > System Information > Service and Repair > Rear Axle Shaft and/or Gasket Replacement > Page 5627

Page 3
background image

13. Remove the inner hub bearing cup using a brass drift and a hammer.

14. Remove the retaining ring from the wheel hub.

15. Remove the outer hub bearing and bearing cup using the J 24426    (2) and the J 8092    (1).

Installation Procedure

1. Lubricate the following with a light coat of high melting point EP bearing lubricant:

*

The outer wheel bearing

*

The inner wheel bearing

*

The outer wheel bearing cup

*

The inner wheel bearing cup

*

The axle hub spindle

Transmission and Drivetrain > Drive Axles, Bearings and Joints > Seals and Gaskets, Drive Axles > System Information > Service and Repair > Rear Axle Shaft and/or Gasket Replacement > Page 5627

[PREV PAGE] [NEXT PAGE]