gmc Workshop Repair Guides

GMC Workshop Service and Repair Manuals

Keyless Entry Transmitter > < Remote Starting System - System Inoperative Diagnostics
Page 2
background image

the engine run time in an RVS attempt before the operator enters the vehicle the ECM may discontinue engine operation if system conditions require it or
a message is received from the BCM requesting the engine be turned OFF.

Reasons an RVS event will NOT Happen

The RVS System WILL NOT operate if any of the following conditions are present:

^

A current vehicle DTC that illuminates the malfunction indicator lamp (MIL) is set - obtain vehicle DTCs.

^

Keyless Entry Transmitter is not Operational.

^

The vehicle is in Valet Mode.

^

RVS is Disabled through Vehicle Personalization.

^

More than 2 Remote Starts have been attempted.

^

The HAZARD switch is in the ON position.

^

A current HAZARD switch DTC is set.

^

A current HOOD AJAR DTC is set.

^

Rear compartment lid is ajar.

^

Any Door is not locked.

^

The Content Theft Deterrent (CTD) system detects an alarm trigger.

^

Engine RPM greater than 0 Detected.

^

Excessive Coolant TEMP is registered.

^

Accelerator pedal position greater than 0 percent.

^

Vehicle is not in PARK.

^

A current Vehicle Theft Deterrent Malfunction DTC.

^

A current Automatic Transmission Shift Lock Control System DTC is set.

^

A vehicle speed sensor signal is detected by the ECM.

^

Vehicle power mode is incorrect.

Diagnostic Information Starting Point

For additional assistance refer to Remote Vehicle Start Inoperative in the Electronic Service Information. This section will guide you through the
complete Strategy Based Diagnostics and provide Specific Diagnostic Procedure Instructions.

Warranty Information

Please refer to the published Labor Time Guides and claim the corresponding labor operation for the component(s) replaced.

Disclaimer

Keyless Entry Transmitter > < Remote Starting System - System Inoperative Diagnostics