Savana 4500 V8-6.6L DSL Turbo (2009)
2. Install the SDM (2) horizontally to the studs.
3. Point the arrow on the SDM toward the front of the vehicle.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
4. Install the SDM mounting nuts (1) and tighten to 10 Nm (89 lb in).
5. Install the SDM (2) electrical connector.
6. Install the CPA to the SDM electrical connector.
7. Install the carpet to cover SDM (2).
8. Install the driver seat. Refer to Driver or Passenger Seat Replacement (See: Body and Frame/Seats/Service and Repair/Driver or Passenger Seat
Replacement).
Note: The AIR BAG indicator may remain ON after the SDM has been replaced. DTC B1001 may set requiring the SDM part number to be set in
multiple modules. If the indicator remains ON after enabling the SIR system, perform the diagnostic system check and follow the steps thoroughly
to ensure that the SDM is set properly.
9. Enable the SIR system. Refer to SIR Disabling and Enabling (See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Air
Bag(s) Arming and Disarming/Service and Repair).
10. Refer to Control Module References (See: Testing and Inspection/Programming and Relearning) for programming and setup information.
