Sierra 1500 2WD V6-4.3L VIN X (2004)
Do not apply force to the steering wheel position sensor and the adapter and bearing assembly in a sideways direction.
Seat the adapter and bearing assembly into the steering column jacket.
5. Connect the steering wheel position sensor connector.
6. Notice:
Refer to Fastener Notice in Service Precautions.
Align the marks on the upper intermediate shaft and the steering column shafts, where they connect, that you made during the removal procedure.
7. Install the intermediate shaft to the steering column pinch bolt.
^
Tighten the nut to 62 Nm (46 ft. lbs.).
8. Connect the negative battery cable.
9. Enable the SIR system.