Sierra 1500 2WD V8-5.3L VIN Z Flex Fuel (2006)
6. Install the caliper to the caliper bracket.
7. Install the brake caliper bolts.
^
Tighten the bolts to 42 Nm (31 ft. lbs.).
8. Install the tire and wheel assembly.
9. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
10. Slowly release the brake pedal.
11. Wait 15 seconds, then repeat steps 10-11 until a firm pedal is obtained. This will properly seat the caliper pistons and pads.
12. Fill the master cylinder reservoir to the proper level with clean brake fluid, if necessary.