Sierra 1500 4WD V8-5.3L VIN Z Flex Fuel (2005)
which you removed the parts. Follow any specifications, torque values, and any measurements made prior to disassembly.
2. Disconnect the propeller shaft from the rear axle pinion yoke.
3. Place an alignment mark between the pinion and the pinion yoke.
4. Install the J 8614-01 as shown.
5. Remove the pinion nut while holding the J 8614-01.
6. Remove the washer.
7. Install the J 8614-2 (2) and the J 8614-3 (3) into the J 8614-01 (1) as shown.
8. Remove the pinion yoke by turning the J 8614-3 (3) clockwise while holding the J 8614-01 (1). Use a container in order to retrieve the lubricant.
9. Remove the pinion oil seal. Use a suitable seal removal tool. Do not damage the axle housing.