Sierra 1500 4WD V8-6.0L VIN U (2006)
1. Remove the center seat.
Caution: Eye protection must be worn when drilling rivets to reduce the chance of personal injury.
2. Remove the rivets (1) retaining the cupholder from the bottom of the center seat.
3. Remove the cupholder.
Installation Procedure
1. Install the cupholder.
2. Install the rivets (1) retaining the cupholder to the bottom of the center seat.
3. Install the center seat.
Switch Replacement - Hot and Cold Cupholder
SWITCH REPLACEMENT - HOT AND COLD CUPHOLDER
REMOVAL PROCEDURE
1. Remove the cupholder assembly.
2. Disconnect the wire connectors from the 2 switches.
-
Switch 1 is the power switch.
-
Switch 2 is the hot and cold switch.
IMPORTANT: Observe the orientation of the switches. The red lights points towards the rear of the vehicle.