Sierra 1500 4WD V8-6.0L VIN U (2006)
Tighten the bolts to 10 N.m (89 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
5. Wipe the excess silicone pressed out during the solenoid installation from around the base of the solenoid to make a weather proof seal.
6. Install the cable to the M-terminal stud between the washers and terminal nut.
7. Tighten the M-terminal stud nut.
Tighten the nut to 8 N.m (71 lb in).
8. Using Three Bond silicone 1207B, GM P/N 97720043, seal the M-terminal stud connection (2).
9. Reposition the M-terminal stud weather cover (1).
10. Bench test the starter in a free-run condition prior to installation.
11. Install the starter motor.