Sierra 1500 4WD V8-6.0L VIN U (2006)
Four Wheel Drive Selector Switch: Service and Repair
NVG 246-NP8 - Transfer Case
Transfer Case Shift Control Switch Replacement
Removal Procedure
1. Remove the instrument panel (I/P) cluster bezel.
2. Using a flat-tipped screwdriver, gently pry the retaining clips open on the housing.
3. Slide out the selector switch until the electrical connector are accessible.
4. Disconnect the selector switch electrical connectors (2, 3).
5. Remove the selector switch from the housing.
Installation Procedure
1. Position the selector switch close to the housing so the electrical connectors can be connected.