Sierra 2500 2WD V8-6.0L VIN U (2004)
1. Install the cable.
2. Snap the retainer tabs into the body mount.
3. Connect the front cable to the intermediate cable.
4. Route the cable in through the floor pan and engage the grommet.
5. Remove the safety stands.
6. Lower the vehicle.
7. Roll the carpet into place.
8. Install the park brake pedal. Refer to Park Brake Pedal Assembly Replacement.
9. Adjust the park brake system.
(W/O NYS)
Park Brake Cable Replacement - Left Rear (w/o NYS)
Removal Procedure
1. Release the park brake.
2. Raise and support the vehicle. Refer Vehicle Lifting