Sierra 2500 2WD V8-6.0L VIN U (2004)
4. Position the input shaft bearing retainer. Align the bearing retainer oil drain hole with the drain hole in the transmission housing.
5. Notice:
Refer to Fastener Notice in Service Precautions.
Install the input shaft bearing retainer bolts.
^
Tighten the bolts to 14 Nm (10 ft. lbs.).
6. Install the clutch actuator cylinder and the bolts.
^
Tighten the bolts to 8 Nm (71 inch lbs.)
7. Install the transmission.
8. Lower the vehicle.
Transmission Housing Oil Seal Replacement - Rear
Transmission Housing Oil Seal Replacement - Rear (2WD)
^
Tools Required
-
J 23129 Universal Seal Remover
-
J 6125-1BSlide Hammer
-
J 36503 Extension Housing Seal Installer
Removal Procedure