Sierra 2500 Denali 2WD V8-6.0L (2011)
4. Insert the J-38125-561 tool into the 2 cavities on each side of the terminal at the front of the connector and push until you feel the tool disengage
the terminal retainers.
5. Carefully pull the terminal out of the connector. Always remember never use force when pulling a terminal out of a connector. If the terminal is
difficult to remove, repeat the entire procedure.
6. Repair the terminal by following the Repairing Connector Terminals (Terminated Lead Repair) (See: General Electrical Diagnostic
Procedures/Connector Repairs/Repairing Connector Terminals (Terminated Lead Repair))Repairing Connector Terminals (Terminal Repair) (
See: General Electrical Diagnostic Procedures/Connector Repairs/Repairing Connector Terminals (Terminal Repair)) procedure.
7. Insert the repaired terminal back into the cavity. Repeat the diagnostic procedure to verify the repair and reconnect the connector bodies.
Bosch Connectors (ECM)
Bosch Connectors (ECM)
Special Tools
*
EL-38125-580 - Terminal Release Tool Kit
*
J-38125-213 - Terminal Release Tool
*
J-38125-556 - Terminal Release Tool
For equivalent regional tools, refer to Special Tools (See: Tools and Equipment).
Terminal Removal Procedure