Sierra 3500 4WD V8-6.0L (2008)
3. If not equipped with active fuel management, perform the following step, using J 41712 or equivalent. Install the oil pressure sensor (706) and
washer (707).
4. Connect the engine harness electrical connector (1) to the oil pressure sensor.
Tighten the sensor to 35 N.m (26 lb ft).
5. Install the intake manifold. Refer to Intake Manifold Replacement (L92 - First Design) (See: Intake Manifold/Service and Repair)Intake Manifold
Replacement (L92 - Second Design) (See: Intake Manifold/Service and Repair)Intake Manifold Replacement (LY2 and LY6) (See: Intake
Manifold/Service and Repair)Intake Manifold Replacement (LH6, LMG, LY5 and L76) (See: Intake Manifold/Service and Repair) .