Sierra 3500 4WD V8-6.0L VIN U (2004)
Stabilizer Link: Service and Repair
Rear Suspension
Stabilizer Shaft Link Replacement (35 Series)
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the stabilizer shaft link nut (5) from the frame (1).
3. Remove the stabilizer link nut from the stabilizer shaft (4).
Installation Procedure
1. Install the stabilizer shaft link to the frame (1) and to the stabilizer shaft and install the retaining nuts (5).
^
Tighten the stabilizer shaft link bolt to the frame (1) to 95 Nm (70 ft. lbs.).
^
Tighten the stabilizer shaft link to the stabilizer shaft to 50 Nm (37 ft. lbs.).
Notice:
Refer to Fastener Notice in Service Precautions.
2. Lower the vehicle.