Sierra 3500 4WD V8-6.6L DSL Turbo VIN 2 (2004)
Wheel Fastener: Service and Repair
Rear Suspension
Wheel Stud Replacement
^
Tools Required
-
J 43631 Ball Joint Remover
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel.
3. Remove the rotor, except dual wheel vehicles.
4. Remove the wheel stud from the axle flange using the J 43631.
5. Remove the axle shaft for vehicles with 9.5 in ring gear.
6. Remove the rear hub assembly for vehicles with 10.5/11.5 in ring gear, with single wheels.
7. Remove the rear axle hub for vehicles with dual wheels. Refer to Rear Axle Hub, Bearing, Cup, and/or Seal Replacement.
8. Remove the wheel stud from the axle flange using the J 43631.
9. Remove the wheel stud from the hub flange using the J 43631.
10. Place the hub and rotor assembly in a press to remove the wheel stud.
Installation Procedure