Sierra 3500 Denali 2WD V8-6.0L (2011)
Engine Mount: Service and Repair
Engine Mount Replacement - Right Side
Engine Mount Replacement - Right Side
Removal Procedure
Caution: When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal, or the crankshaft pulley. Due to the
small clearance between the oil pan and the oil pump screen, jacking against the oil pan may cause the pan to be bent against the pump screen. This will
result in a damaged oil pickup unit.
1. Remove the upper intake manifold sight shield. Refer to Upper Intake Manifold Cover Replacement (See: Intake Manifold/Service and Repair).
2. If the vehicle is equipped with four wheel drive (4WD), remove the front drive axle. Refer to Differential Carrier Assembly Replacement (1500
4WD) (See: Transmission and Drivetrain/Differential Assembly/Service and Repair/Removal and Replacement/Front Drive Axle/Differential
Carrier Assembly Replacement (1500 4WD))Differential Carrier Assembly Replacement (2500 4WD) (See: Transmission and
Drivetrain/Differential Assembly/Service and Repair/Removal and Replacement/Front Drive Axle/Differential Carrier Assembly Replacement
(2500 4WD)).
3. Remove the two lower engine mount to engine bolts (1).
4. Remove the starter motor. Refer to Starter Replacement (V8) (See: Starting and Charging/Starting System/Starter Motor/Service and Repair
)Starter Replacement (V6) (See: Starting and Charging/Starting System/Starter Motor/Service and Repair)Starter Replacement (Diesel) (See:
Starting and Charging/Starting System/Starter Motor/Service and Repair).