Sierra 3500 Denali 2WD V8-6.0L (2011)
1. Install the control lever insulator (5) to the floor.
2. Assemble the control lever boot retaining bezel (1) to the boot (4) and insert the 4 plastic retainers (3).
3. Install the control lever boot retaining bezel (1), boot (4) and secure the 4 plastic retainers (3) to the floor.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
4. Lift and push the lower edge of the control lever boot as necessary in order to install the 4 retaining screws (2).
Tighten the screws to 1.6 Nm (14 lb in).
5. Install the transmission control lever. Refer to Transmission Control Lever Knob Replacement (See: Transmission Control Lever Knob
Replacement).
Transmission Control Lever Knob Replacement
Transmission Control Lever Knob Replacement
Removal Procedure
1. Remove the control lever boot from the control lever.
Note: DO NOT move the shift lever assembly adjustment nut if replacing the control lever.
2. Remove the control lever.
Installation Procedure
1. Install the control lever.
2. If alignment of the control lever is necessary, or if the shift lever assembly was replaced perform the following:
1. The nut must be seated at the bottom of the thread runout on the shift lever.
2. Seat the control lever against the shift lever assembly adjustment nut.
3. Back the control lever off the nut in order to align the index mark on the control lever perpendicular to the edge of the control lever boot
retainer.
4. Ensure that the index mark is located on the passenger side and that the shift pattern is aligned parallel to the vehicle centerline or rotated no
more than 6 degrees clockwise.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
5. Hold the control lever and tighten the shift lever assembly nut against the control lever.