Sierra Classic 1500 2WD V8-4.8L (2007)
DO NOT substitute with vinyl electrical tape or friction tape. Use only the tape specified above.
15. Tape the harness starting at the MSM connectors (1) extending back to the new break-out location (2) in the plastic carrier.
16. Install a plastic tie strap around the harness and the plastic carrier at the break-out point (1).
17. Install the new harness edge clip (1) 10 mm (0.4 in) further from the connectors and the existing harness clip. Ensure the clip is installed in the
orientation shown.
18. Install the harness with the new harness clip in the location shown (1).