Sierra Classic 1500 2WD V8-4.8L (2007)
18. Remove the torsion bar bracket, if equipped with 4WD.
19. Remove the EVAP canister.
20. Disconnect the fuel line at the tank.
21. Cap the fuel and EVAP lines in order to avoid possible system contamination.
22. Remove the fuel/EVAP bundle clip nuts.
23. Remove the fuel/EVAP bundle.
INSTALLATION PROCEDURE
1. Install the fuel/EVAP bundle.
NOTE: Refer to Fastener Notice.
2. Install the fuel/EVAP bundle clip nuts.
Tighten the nuts to 12 N.m (106 lb in).
3. Remove the caps from the fuel and EVAP lines.
4. Connect the fuel line at the tank.
5. Install the EVAP canister.
6. Install the torsion bar bracket, if equipped with 4WD.