Sierra Classic 1500 4WD V6-4.3L (2007)
7. Install the distributor hold-down bolt.
Tighten the bolt to 25 N.m (18 lb ft).
8. Install the distributor cap.
9. Install NEW distributor cap screws.
Tighten the screws to 2.4 N.m (21 lb in).
10. Connect the following electrical connectors:
-
CMP sensor (2)
-
Fuel pump/oil pressure sensor (3)
IMPORTANT: The coil wire nipple must be positioned such that it is between 35 and 60 degrees aft of perpendicular as referenced from
the engine centerline on the outboard side of the coil.