Sierra Denali V8-6.0L VIN N (2005)
Control Arm: Service and Repair
Upper Control Arm Replacement
The content of this article/image reflects the changes identified in TSB
Bulletin No.: 06-03-08-002
Date: March 09, 2006
SERVICE MANUAL UPDATE
Subject:
Revised Upper Control Arm Replacement
Models:
2003-2006 Cadillac Escalade Models
2003-2006 Chevrolet Avalanche, Silverado, Suburban, Tahoe Models
2003-2006 GMC Sierra, Yukon Models
2003-2006 HUMMER H2
Use of special tool J 42188-B eliminates the need to remove the wheel drive shaft on 4WD models.
Upper Control Arm Replacement (Escalades, Avalanche, Silverado, Sierra, Suburban, Tahoe, Yukons)
Tools Required
J 42188-B Ball Joint Separator
Removal Procedure
1. Raise and support the vehicle.
2. Remove the tire and wheel.
3. Disconnect the electronic suspension control (ESC) link rod from the sensor, if equipped. Refer to Front Position Sensor Link Assembly -
Electronic Suspension in Electronic Suspension Control.
4. Remove the retaining bolt for the brake hose and the wheel speed sensor brackets.