Sierra Denali RWD V8-6.2L (2009)
7. Position the J-9522-5 - U-Joint Bearing Spacer Remover (1) on the universal joint.
Note
The following procedure is also used for the breaking of the nylon injected ring for those universal joints that are equipped.
8. Using the J-9522-3 - Separator ,J-9522-5 - Remover and a press, remove the universal bearing from the yoke.
9. Rotate the propeller shaft and repeat steps 1-8 to remove the opposite universal joint.
Note
If the slip yoke is found to be damaged, replace the slip yoke and use a NEW universal joint. DO NOT re-use the old universal joint.
10. Remove the slip yoke (1) from the propeller shaft (2).