Sierra Denali RWD V8-6.2L (2009)
1. Install the control lever insulator (5) to the floor.
2. Assemble the control lever boot retaining bezel (1) to the boot (4) and insert the 4 plastic retainers (3) .
3. Install the control lever boot retaining bezel (1), boot (4) and secure the 4 plastic retainers (3) to the floor.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution) .
4. Lift and push the lower edge of the control lever boot as necessary in order to install the 4 retaining screws (2).
Tighten the screws to 1.6 Nm (14 lb in).
5. Install the transmission control lever. Refer to Transmission Control Lever Knob Replacement (See: Transmission Control Lever Knob
Replacement) .
Transmission Control Lever Knob Replacement
Transmission Control Lever Knob Replacement
Removal Procedure
1. Remove the control lever boot from the control lever.
Note
DO NOT move the shift lever assembly adjustment nut if replacing the control lever.
2. Remove the control lever.
Installation Procedure