Suburban 1/2 Ton 4WD V8-379 6.2L DSL (1985)
Headliner: All Technical Service Bulletins
Rear Inner Headliner Roof Molding - Sagging
CHEVROLET NUMBER 87-T-41
SECTION:
10 - Body Section
DATE:
January, 1987
SUBJECT:
REAR INNER HEADLINER ROOF MOLDING
MODELS:
1979-1984 C/K, 1985-1986 K, AND 1987 V JIMMY/BLAZER
During high in-vehicle temperatures, the rear headliner roof molding on the subject models may warp or sag. If this condition occurs, a new molding,
P/N 15554978, has been released for service. This new molding has four additional screws retaining the molding to the roof inner panel.
Figure No. 1 - Replacing Rear Headliner Roof Molding
To install, place the new molding into position and attach at each end using existing holes (See Figure No. 1). Drill four 1/8" holes into the roof
inner panel that correspond to the holes in the new molding. Attach using screws, P/N 11504659.
Beginning with the following VIN breakpoints, the new molding was incorporated into production.
Chevrolet
-
HF187901
GMC
-
HF527088