Suburban 3/4 Ton 4WD V8-305 5.0L (1986)
side of shaft as the rotor pointer. Temporarily install rotor to ensure correct alignment.
8.
Install tanged washer, shim and drive gear, then retain with a new roll pin.
9.
Install capacitor and loosely install retaining screw.
10.
Install connector on module with tab on top, then liberally apply silicone grease to bottom of module and install screws. Failure to apply silicone
grease to module will cause excessive heat build up of module and premature failure.
11.
Position wiring harness with grommet in housing notch, then connect pink wire to capacitor stud and black wire to capacitor retaining screw.
Tighten screw.
12.
Reconnect wires to module, then install centrifugal advance weights and springs.
