Suburban 3/4 Ton 4WD V8-305 5.0L (1986)
Wheels: All Technical Service Bulletins
Wheels, Aluminum - Clear Coating
NUMBER:
86-B-98
GROUP:
3E - Wheels & Tires
DATE:
July, 1986
SUBJECT:
CLEAR COATING OF ALUMINUM WHEELS
MODELS:
ALL S/T AND C/K MODELS EQUIPPED WITH ALUMINUM WHEELS
THIS BULLETIN CANCELS AND SUPERSEDES 85-B-60 (MARCH, 1985), ALL COPIES OF WHICH SHOULD BE DESTROYED.
The purpose of this service bulletin is to assist dealerships in repairing the discoloration or surface degradation that has been experienced on certain style
cast aluminum wheels.
SERVICE REPAIR PROCEDURE
I.
Wheel Removal Mark wheel and tire for position on vehicle. Remove wheel and tire assembly from vehicle. Mask off tire prior to painting. Mark
location of outboard weights and remove.
Wash wheel inside and out with water base all purpose cleaner. Remove grease and oil with solvent cleaner.
II. Surface Preparation
Note:
It is not necessary to remove tire from wheel assembly to perform this procedure, however, if for any reason the tire is removed, its position to
the wheel must be marked using the valve stem as an index. When remounting, tire should be returned to original position on wheel.
A.
Surface Damage, Clear Coat Damage
1.
Mount wheel on brake lathe and spin slowly.
a.
Sand wheel with backing block or pad by holding abrasive flat to surface of wheel and moving slowly back and forth from center to
outer edge to remove imperfections.
1)
Sand with 80 grit*
2)
Sand with 150 grit
3)
Sand with 240 grit
*Never use abrasive coarser than 80 grit
B.
Slight Clear Coat Damage On Unpainted Wheels.
1.
Apply chemical stripper - allow stripper to penetrate coating.
Special Note - Use small 1/4" detail brush dipped in stripper to apply material around perimeter and spoke-like areas.
2.
Remove stripper - follow manufacturers recommendations.
3.
Sand wheel with 240 grit while rotating wheel on a slow spinning brake lathe or by mounting on vehicle and spinning by hand. This
step is to restore the machined appearance and to promote adhesion.
WARNING:
Do not use vehicle power to rotate wheel while sanding to avoid serious personal injury.
III. Recoating Procedure
A.
Clean surface of contaminants.
B.
Spray wheel with Amchem #33 or equivalent, let soak from 1 to 3 minutes, then rinse with water and blow dry.
C.
Spray wheel with Amchem #1001 or equivalent, let soak from 1 to 3 minutes, then rinse with water and blow dry.
D.
Finish with Ditzler Delclear Acrylic Urethane and Ditzler Ultra Urethane additive or equivalent. Three coats.
1st Coat -Light mist coat, let flash 2nd Coat - Light, let flash 3rd Coat - Heavy double wet coat
