Suburban 3/4 Ton 4WD V8-305 5.0L (1986)
Clutch Master Cylinder: Service and Repair
REMOVAL
1. Disconnect battery ground cable.
2. Remove lower steering column covers, then if equipped with A/C, remove A/C duct from lower left side of instrument cluster.
3. Disconnect master cylinder push rod from clutch pedal, then remove retaining nuts at dash panel.
4. Disconnect reservoir hose and salve cylinder hydraulic line at master
cylinder, then remove master cylinder from vehicle.
INSTALLATION
1. Install master cylinder assembly and torque retaining nuts to 10-14 ft. lbs.
2. Connect slave cylinder hydraulic line and reservoir hose to master cylinder.
3. Connect push rod to clutch pedal, then install retaining clip and A/C duct if equipped.
4. Install lower steering column covers, then reconnect battery ground cable.
5. Fill master cylinder reservoir with clean brake fluid, then bleed system as described under "Clutch System, Bleed."
