Suburban 3/4 Ton 4WD V8-305 5.0L (1986)
Fig. 17 Removing centering ball
Ball Socket
1.
To remove ball, separate universal joint between coupling yoke and flange yoke by pressing out trunnion bearing in coupling yoke. Pull flange
yoke and cross with ball socket from centering ball as a unit.
2.
Clean and inspect ball seat insert bushing for wear. If worn, replace flange yoke and cross assembly.
3.
Pry seal from ball cavity, then remove washers, spring and ball seats.
4.
Clean and inspect centering ball surface, seal, ball seats, spring and washer. If parts are worn or broken, replace with a service kit.
5.
Remove centering ball as shown in Fig. 17, using components of tool C-4365 or equivalent. Install components as shown, and draw ball off ball
stud.
Assembly
Fig. 12 Alignment Punch Marks
