Suburban 3/4 Ton 4WD V8-393 6.5L DSL Turbo (1993)
1. Module and glass assembly into the door.
^
Fit the glass into the rear channel inside the door.
2. Upper run channel bolt and tighten it.
3. Lock and handle rods to the back of the module.
4. Wiring connector (if present).
^ Pull the wiring through the boot and connect it inside the door hinge pillar.
5. New water deflector. Refer to Door Inner Panel Water Deflector.
6. Top front and the top rear module screws.
7. Module to door screws.
8. Lower run channel bolt.
9. Door trim panel. Refer to Door Trim Panel.
