Syclone V6-262 4.3L Turbo (1991)
Tools Required:
J 9399-A Compressor Shaft Nut Socket
J 9401-A Hub and Drive Plate Assembly Installer
J 25030-A Clutch Hub Holding Tool
1. Shaft key (36).
Aligning The Drive Plate Key
-
Allow the shaft key (36) to extend 4.5 mm (3/16-inch) out of the bottom of the hub keyway.
-
The shaft key (36) is curved to give an interference fit in the groove.
Important
-
Do not drive or pound or the clutch hub or the shaft (39). Internal damage to the compressor may result.
2. Clutch plate and hub assembly (2).
-
Install the clutch plate and hub assembly (2) over the compressor shaft lining up the key slot on the hub with the keyway slot in the shaft.